Thingmagic Autonomous Configuration Tool Bedienungsanleitung PDF herunterladen (Seite 15)

Configure

Autonomous Configuration Tool v1.0 User Guide 15

Configure

After a successful Connect to a reader the Configure tab, as shown in Figure 3, provides

all the available autonomous reading settings. In addition you can install firmware,

configure the Read

display options and check the current firmware version of the

connected reader.

Figure 3: Configure Tab

WARNING!

Once Apply is clicked all selected settings will be saved to the connected reader.

This may cause the reader to start reading at 100% duty cycle.

Read & Write Settings

This sections allows the basic behavior of a autonomous reading to be defined.

The following configuration settings can be defined for autonomous operation:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Keine Kommentare

Thingmagic Autonomous Configuration Tool Bedienungsanleitung Seite 15