Thingmagic M5e-Compact Bedienungsanleitung PDF herunterladen (Seite 167)

Set Application Commands

Command Set 167

Note

Setting the parameters using Set Protocol Configuration will override the

implicit value set by a previous call to Set User Mode. Likewise, a

subsequent call to Set User Mode will override the parameters set by Set

Protocol Configuration. Get Protocol Configuration will always return the

current setting regardless of whether it was set by Set Protocol

Configuration or Set User Mode.

Note

Changing these protocol parameters manually using

Set Protocol Configuration

(9Bh) will maintain their value across changes in the current protocol using

Set Current Tag Protocol (93h). Their values will NOT be reset if the protocol is

reset, only if the module is power cycled or the application firmware is

reloaded by a Start Bootloader (09h) followed by a Boot Firmware (04h).

Examples

Session

The following example sets the Gen2 session to S2:

Q Value

The Q valued can be set to a static user specified value or to dynamically change based

on ThingMagic internal algorithms. When using the dynamic Q setting the Value

parameter is dropped in the command.

The following example statically sets the Q value to 6:

The following example sets dynamic Q value adjusting:

FF 03 9B 05 00 02 DC EA

SOH Length OpCode Protocol Parameter Value CRC

FF 04 9B 05 12 01 06 80 A9

SOH Length OpCode Protocol Parameter Option Value CRC

FF 03 9B 05 12 00 CE E8

SOH Length OpCode Protocol Parameter Option CRC

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 251 252

Keine Kommentare

Thingmagic M5e-Compact Bedienungsanleitung Seite 167